5 Best Of How To Do Corners On Felt Roof Best Wallpaper JPG. Repeat this with each roll until the roof is covered overlapping each sheet by about 38 in 095 cm. There are two good ways to handle corner flashing.
Roll back one half of the length of the sheet to the centre of the roof taking care to maintain the sheet alignment. Run the base flashing 4 to 5 in. After the roofing felt as been rolled along with the roof.
Lay the roll of roofing felt on the corner and let it overhang by three inches on each side.
Once it is cut to the correct size start at the centre of the sheet and work towards one of the edges placing nails at random intervals. The original builder rot him put a 30cm parapit around it with one brick removed to allow the water to escape. Fold the excess felt at each corner of the roof outwards to make a flap and then fold it back along the eaves and nail it into place. Beyond the dormer and cut the top section along the dormer edge.